SolidWorks Auger Macro
A conversation-specific public summary of solidworks auger macro, distilled from the supplied export. The detailed excerpts remain available in the released note file.
An auger follows the start-to-end path
OPEN FULL SIZE ↗- Direction
- POINT2 start → POINT1 end
- ID / OD
- 0.39 in / 0.80 in
- Thickness
- 0.1875 in, described as 7 ga stainless
- Revolutions
- 16
TECHNICAL NOTES///
Conversation-specific knowledge extracted from the solidworks auger macro discussion.
QUESTION / CONTEXTI NEED A MACRO FOR SOLIDWORKS 2025 THAT CREATES AN AUGER TYPE SHAPE STARTING AT "AUGSTART" PLANE AND ENDS AT "AUGEND" PLANE THE SPECS OF THE AUGER ARE THIS .39 ID .80 OD 16 REVOLUTIONS AND IT IS MADE OUT OF 7 GA STAINLESS PLATE ALSO IF NEEDED I CREATED "POINT2" AT THE START OF THE AUGER AND "POINT1" AT THE END OF THE AUGER THAT CAN BE USED AS CENTER POINTS
IMPORTANT GUIDANCE
- POINT2 = auger start center
- POINT1 = auger end center
- AUGSTART and AUGEND already exist
- 7 ga stainless = 0.1875 in thickness
- ID = 0.39 in
- OD = 0.80 in
- 16 revolutions
- a 3D path from POINT2 to POINT1
Extracted from the conversation’s assistant responses and edited for public clarity. See the released note for additional redacted excerpts.
DEVELOPMENT HISTORY///
Matched to the supplied export; key guidance is surfaced separately and the raw transcript remains unpublished.
SPECIFICATION///
RELEASED MATERIAL///
RECOVERED / SPECIFIC NOTE
The record keeps what is known at this revision. Unfinished tests stay unfinished here.