← RETURN TO RECORDDOWNLOAD PDF ↓

U225X / ENGINEERING UNWARRANTED

Koozie Holder Print Failure

Public record / CHAT-0227 / Revision EXPORT-03

PUBLIC RECORD
U225X

A conversation-specific public summary of koozie holder print failure, distilled from the supplied export. The detailed excerpts remain available in the released note file.

STATUSRECOVERED / SPECIFIC NOTECLASSIFICATIONEXPMATERIALCHAT EXPORT / FIELD & NATUREDATE2026.07.25

TECHNICAL NOTES

Conversation-specific knowledge extracted from the koozie holder print failure discussion.

EXTRACTED KNOWLEDGE / HOW-TO FROM CONVERSATION

QUESTION / CONTEXT: The bottom of the koozie holder warped pretty bad and it failed again at the very top and knocked over also the super thin supports dont break off at all.

  1. Bed temperature too low.
  2. Cooling fan too aggressive on the first few layers.
  3. Build plate wasn't completely clean.
  4. Large flat part shrinking as it cools.
  5. Increase bed temperature 5-10°C (if printing PLA, try 60-65°C).
  6. Wash the build plate with hot water and Dawn, then wipe with IPA.
  7. Turn off auxiliary cooling for the first 5-10 layers if your slicer allows it.
  8. Add a 10-15 mm brim around the entire part (not just mouse ears).

SPECIFICATION

SourceSupplied ChatGPT export
CategoryField & Nature
Conversation5 user turns / 8 assistant turns
Attachments47 references detected
Public detailExtracted knowledge + excerpts

DEVELOPMENT HISTORY

2026.07.25EXPORT-04Matched to the supplied export; key guidance is surfaced separately and the raw transcript remains unpublished.