A conversation-specific public summary of koozie holder print failure, distilled from the supplied export. The detailed excerpts remain available in the released note file.
CHAT-0227REV EXPORT-03
AI narration using Robert's voice. Koozie Holder Print Failure / short introduction.
Conversation-specific knowledge extracted from the koozie holder print failure discussion.
EXTRACTED KNOWLEDGE / HOW-TOFROM CONVERSATION
QUESTION / CONTEXTThe bottom of the koozie holder warped pretty bad and it failed again at the very top and knocked over also the super thin supports dont break off at all.
IMPORTANT GUIDANCE
Bed temperature too low.
Cooling fan too aggressive on the first few layers.
Build plate wasn't completely clean.
Large flat part shrinking as it cools.
Increase bed temperature 5-10°C (if printing PLA, try 60-65°C).
Wash the build plate with hot water and Dawn, then wipe with IPA.
Turn off auxiliary cooling for the first 5-10 layers if your slicer allows it.
Add a 10-15 mm brim around the entire part (not just mouse ears).
Extracted from the conversation’s assistant responses and edited for public clarity. See the released note for additional redacted excerpts.
DEVELOPMENT HISTORY///
2026.07.25EXPORT-04
Matched to the supplied export; key guidance is surfaced separately and the raw transcript remains unpublished.
OPEN FULL SIZE ↗