SolidWorks 2025 Cut Method
A conversation-specific public summary of solidworks 2025 cut method, distilled from the supplied export. The detailed excerpts remain available in the released note file.
An end-plane cut with incomplete offsets
OPEN FULL SIZE ↗- Offsets recorded
- 1.06; 1.25, units unspecified
- Constraint
- Final segment 90° to main face
- Goal
- Fully defined sketch
TECHNICAL NOTES///
Conversation-specific knowledge extracted from the solidworks 2025 cut method discussion.
QUESTION / CONTEXTi have a smetal part in solid works 2025 that needs an odd cut to happen to it what the best way to go about this. the leg closest to us needs the corner point shifted 1.06 the next point marked needs to be shifted 1.25 and then the final cut is 90 to the rest of the part
RETAINED REPLY
- --
- Create a Plane on the end of the part (or use the end face if it works)
- This is just your sketching reference
- Draw the profile that matches what you sketched in red:
- Bottom point → shift 1.06
- Next corner → shift 1.25
- Final segment → make it 90° to the main face
- Fully define this sketch
Extracted from the conversation’s assistant responses and edited for public clarity. See the released note for additional redacted excerpts.
DEVELOPMENT HISTORY///
Matched to the supplied export; key guidance is surfaced separately and the raw transcript remains unpublished.
SPECIFICATION///
RELEASED MATERIAL///
RECOVERED / SPECIFIC NOTE
The record keeps what is known at this revision. Unfinished tests stay unfinished here.