← RETURN TO RECORDDOWNLOAD PDF ↓

U225X / ENGINEERING UNWARRANTED

Printing Sleeve Bushing Tips

Public record / CHAT-0278 / Revision EXPORT-03

PUBLIC RECORD
U225X

A conversation-specific public summary of printing sleeve bushing tips, distilled from the supplied export. The detailed excerpts remain available in the released note file.

STATUSRECOVERED / SPECIFIC NOTECLASSIFICATIONSYSMATERIALCHAT EXPORT / BUILD & TOOLSDATE2026.04.06

TECHNICAL NOTES

Conversation-specific knowledge extracted from the printing sleeve bushing tips discussion.

EXTRACTED KNOWLEDGE / HOW-TO FROM CONVERSATION

QUESTION / CONTEXT: Ok I need to print a sleeve bushing out of pla. Here are the measurments, .6875 od and .625 id it will be 2 inches tall. I want to print this like I did my washer, all walls. Any suggestions for getting the correct size off the first print? Im not opposed to scaling the model to get there

  1. Let’s get you dialed in so your *first print is damn close* instead of guessing 3–4 times.
  2. --
  3. ODs print slightly oversized
  4. IDs (holes) print undersized ← this is your main problem
  5. Tall thin parts (2" tall tube) can get a little oval if cooling isn’t great
  6. OD: 0.6875" (11/16)
  7. ID: 0.625" (5/8)
  8. Length: 2.000"

SPECIFICATION

SourceSupplied ChatGPT export
CategoryBuild & Tools
Conversation1 user turns / 1 assistant turns
Attachments1 references detected
Public detailExtracted knowledge + excerpts

DEVELOPMENT HISTORY

2026.04.06EXPORT-04Matched to the supplied export; key guidance is surfaced separately and the raw transcript remains unpublished.