← RETURN TO INDEX
OPEN FULL SIZE ↗Illustrative slicer cross-section from the recorded profile.Explanatory drawing based on this record
RECORD LOCATED / 2025.12.14
Printing flat parts settings
A conversation-specific public summary of printing flat parts settings, distilled from the supplied export. The detailed excerpts remain available in the released note file.
CHAT-0276REV EXPORT-03
AI narration using Robert's voice. Printing flat parts settings / short introduction.
A CLOSER LOOK
Flat-part shells and first-layer widths
OPEN FULL SIZE ↗- Layer heights
- 0.20 mm regular; 0.24 mm first
- Line widths
- 0.42 mm default; 0.45 mm first
- Walls
- 3
- Top/bottom
- 5–6 layers at 0.20 mm
CLASSIFICATIONSYS
STATUSRECOVERED / SPECIFIC NOTE
MATERIALCHAT EXPORT / BUILD & TOOLS
DISPOSITIONPUBLIC CONVERSATION EXCERPTS / REDACTED
TECHNICAL NOTES///
Conversation-specific knowledge extracted from the printing flat parts settings discussion.
EXTRACTED KNOWLEDGE / HOW-TOFROM CONVERSATION
QUESTION / CONTEXTWhat are some good settings with normal pla and .4 nozzle to print flat parts on an adventurer 5m using orca
IMPORTANT GUIDANCE
- Layer height: 0.20 mm (use 0.16 if you want prettier top surfaces)
- First layer height: 0.24 mm
- Line width:
- Default: 0.42 mm
- First layer: 0.45 mm
- Perimeters (walls): 3 (2 is ok, 3 helps flat parts stay stiff)
- Top / bottom layers: 5–6 (at 0.20mm)
- Nozzle: 210°C first layer, then 205°C
Extracted from the conversation’s assistant responses and edited for public clarity. See the released note for additional redacted excerpts.
DEVELOPMENT HISTORY///
2025.12.14EXPORT-04
Matched to the supplied export; key guidance is surfaced separately and the raw transcript remains unpublished.
SPECIFICATION///
SourceSupplied ChatGPT export
CategoryBuild & Tools
Conversation2 user turns / 2 assistant turns
Attachments2 references detected
Public detailExtracted knowledge + excerpts
RELEASED MATERIAL///
WHERE THIS STANDS
RECOVERED / SPECIFIC NOTE
The record keeps what is known at this revision. Unfinished tests stay unfinished here.