Bushing for Trailer Ramp
A conversation-specific public summary of bushing for trailer ramp, distilled from the supplied export. The detailed excerpts remain available in the released note file.
The thin wall in the ramp bushing
OPEN FULL SIZE ↗- OD
- 0.6875 in
- ID
- 0.625 in
- Radial wall
- 0.03125 in = 1/32 in
TECHNICAL NOTES///
Conversation-specific knowledge extracted from the bushing for trailer ramp discussion.
QUESTION / CONTEXTThis guy is wanting a bushing .6875 outside diameter and .625 inside diameter and 2 inches ling for this purpose I would be using it as a wear bushing over a bolt on an aluminum trailer folding ramp.
IMPORTANT GUIDANCE
- OD = 0.6875"
- ID = 0.625"
- Wall thickness = (0.6875 - 0.625) / 2 = 0.03125"
- So that is only 1/32" wall
- the ramp has any side-load
- the bolt is not perfectly aligned
- the joint sees bouncing/vibration going down the road
- the ramp gets slammed open/closed
Extracted from the conversation’s assistant responses and edited for public clarity. See the released note for additional redacted excerpts.
DEVELOPMENT HISTORY///
Matched to the supplied export; key guidance is surfaced separately and the raw transcript remains unpublished.
SPECIFICATION///
RELEASED MATERIAL///
RECOVERED / SPECIFIC NOTE
The record keeps what is known at this revision. Unfinished tests stay unfinished here.