A conversation-specific public summary of 3d print nesting tips, distilled from the supplied export. The detailed excerpts remain available in the released note file.
CHAT-0025REV EXPORT-03
AI narration using Robert's voice. 3D Print Nesting Tips / short introduction.
Conversation-specific knowledge extracted from the 3d print nesting tips discussion.
EXTRACTED KNOWLEDGE / HOW-TOFROM CONVERSATION
QUESTION / CONTEXTi have these 4 parts i need to 3d print proto types of, i have the min solid works is there a way to nest them so the print together and stay clean
IMPORTANT GUIDANCE
Insert all four parts.
Mate them so they sit flat on the build plate.
Leave 0.080-0.120 in (2-3 mm) between each part.
Save the assembly as a single STL.
Slice it.
--
040-.060 thick
0.040–0.060" thick
Extracted from the conversation’s assistant responses and edited for public clarity. See the released note for additional redacted excerpts.
DEVELOPMENT HISTORY///
2026.07.15EXPORT-04
Matched to the supplied export; key guidance is surfaced separately and the raw transcript remains unpublished.
OPEN FULL SIZE ↗