← RETURN TO INDEX
OPEN FULL SIZE ↗A schematic ribbed flexible wall shows support underneath the ridges and inward compression. It is an explanatory section, not the approved case geometry.Explanatory drawing based on this record
RECORD LOCATED / 2026.01.12
TPU Printing with 0.6 Nozzle
A conversation-specific public summary of tpu printing with 0.6 nozzle, distilled from the supplied export. The detailed excerpts remain available in the released note file.
CHAT-0379REV EXPORT-03
AI narration using Robert's voice. TPU Printing with 0.6 Nozzle / short introduction.
A CLOSER LOOK
Ribs over a compressible wall
OPEN FULL SIZE ↗- Texture
- Ribbed exterior
- Support
- Even material under ribs
- Behavior
- Soft compression
CLASSIFICATIONSYS
STATUSRECOVERED / SPECIFIC NOTE
MATERIALCHAT EXPORT / BUILD & TOOLS
DISPOSITIONPUBLIC CONVERSATION EXCERPTS / REDACTED
TECHNICAL NOTES///
Conversation-specific knowledge extracted from the tpu printing with 0.6 nozzle discussion.
EXTRACTED KNOWLEDGE / HOW-TOFROM CONVERSATION
QUESTION / CONTEXTI need to print this with TPU but only have a .6 nozzle its about 5" x 2" by 1/2" tall
IMPORTANT GUIDANCE
- --
- Soft compression
- No collapse
- Even support under the ribs
- Use a glue stick on the plate
- The ribbed texture will be clean
- The logo will still look good with a 0.6
- It’ll be durable, grippy, and flexible
Extracted from the conversation’s assistant responses and edited for public clarity. See the released note for additional redacted excerpts.
DEVELOPMENT HISTORY///
2026.01.12EXPORT-04
Matched to the supplied export; key guidance is surfaced separately and the raw transcript remains unpublished.
SPECIFICATION///
SourceSupplied ChatGPT export
CategoryBuild & Tools
Conversation6 user turns / 6 assistant turns
Attachments21 references detected
Public detailExtracted knowledge + excerpts
RELEASED MATERIAL///
WHERE THIS STANDS
RECOVERED / SPECIFIC NOTE
The record keeps what is known at this revision. Unfinished tests stay unfinished here.