A conversation-specific public summary of sweep cut along 3d sketch, distilled from the supplied export. The detailed excerpts remain available in the released note file.
CHAT-0367REV EXPORT-03
AI narration using Robert's voice. Sweep Cut along 3D Sketch / short introduction.
OPEN FULL SIZE ↗A curve, its starting tangent and a perpendicular profile plane explain the setup for the sweep cut.Explanatory drawing based on this record
Conversation-specific knowledge extracted from the sweep cut along 3d sketch discussion.
EXTRACTED KNOWLEDGE / HOW-TOFROM CONVERSATION
QUESTION / CONTEXTI have this sheet metal cut and 3d sketch that intersect it, i need to cut along the 3d sketch to the outside of the part in solid works 2025
IMPORTANT GUIDANCE
--
Start a new sketch on a plane normal to the start of your 3D sketch
If needed:
Select the start point of your 3D sketch
Select the 3D sketch curve → make plane normal
In that sketch:
Draw a line or very thin rectangle
This defines your cut thickness
Extracted from the conversation’s assistant responses and edited for public clarity. See the released note for additional redacted excerpts.
DEVELOPMENT HISTORY///
2026.04.21EXPORT-04
Matched to the supplied export; key guidance is surfaced separately and the raw transcript remains unpublished.
OPEN FULL SIZE ↗