A conversation-specific public summary of emboss marks in inventor, distilled from the supplied export. The detailed excerpts remain available in the released note file.
CHAT-0161REV EXPORT-03
AI narration using Robert's voice. Emboss marks in Inventor / short introduction.
Conversation-specific knowledge extracted from the emboss marks in inventor discussion.
EXTRACTED KNOWLEDGE / HOW-TOFROM CONVERSATION
QUESTION / CONTEXTI am wanting to add marks or an emboss to the rolled sheet metal part in inventor. for locating welds on the stiffener. how would I go about this it is Inventor 2023
IMPORTANT GUIDANCE
--
Convert to Sheet Metal
Make sure your rolled part is a true Sheet Metal part, not a solid.
You should already have a Flat Pattern.
Create Flat Pattern
Sketch on Flat Pattern
Right-click Flat Pattern → Edit
Create a 2D Sketch on the flat face
Extracted from the conversation’s assistant responses and edited for public clarity. See the released note for additional redacted excerpts.
DEVELOPMENT HISTORY///
2025.12.19EXPORT-04
Matched to the supplied export; key guidance is surfaced separately and the raw transcript remains unpublished.
OPEN FULL SIZE ↗