← RETURN TO RECORDDOWNLOAD PDF ↓

U225X / ENGINEERING UNWARRANTED

Dimensioning in SolidWorks

Public record / CHAT-0139 / Revision EXPORT-03

PUBLIC RECORD
U225X

A conversation-specific public summary of dimensioning in solidworks, distilled from the supplied export. The detailed excerpts remain available in the released note file.

STATUSRECOVERED / SPECIFIC NOTECLASSIFICATIONSYSMATERIALCHAT EXPORT / BUILD & TOOLSDATE2026.04.16

TECHNICAL NOTES

Conversation-specific knowledge extracted from the dimensioning in solidworks discussion.

EXTRACTED KNOWLEDGE / HOW-TO FROM CONVERSATION

QUESTION / CONTEXT: HOW DO I DIMENSION THIS

  1. *Dimension it centerline-to-edge as a radius location, or edge-to-edge if that flat is what matters functionally.
  2. Use Smart Dimension from the centerline of the hole to the right outside arc, then make it a radius/center distance as needed.
  3. the vertical tangent point / virtual sharp where the straight wall starts on the left
  4. to the vertical tangent point / virtual sharp on the right
  5. Start Smart Dimension
  6. Click the left arc/edge
  7. Click the right arc/edge
  8. Move the cursor below the view so it becomes a horizontal dimension

SPECIFICATION

SourceSupplied ChatGPT export
CategoryBuild & Tools
Conversation1 user turns / 1 assistant turns
Attachments7 references detected
Public detailExtracted knowledge + excerpts

DEVELOPMENT HISTORY

2026.04.16EXPORT-04Matched to the supplied export; key guidance is surfaced separately and the raw transcript remains unpublished.