CREATOR 5 PRO / RECOVERED PRINT JOBS
Record: DAT-0026 / Revision A
Status: Recovered job summaries; not complete profiles

FOUR-COLOR PLA + TPU CUBE / TEST PRINT
Nozzle: 0.4 mm. Prime tower: enabled. Slot 1: TPU 95A. Slots 2–4: PLA.
Estimated print time: 12 minutes 44 seconds. Estimated material: 2.02 g.
Visible send options: leveling, flow calibration, and time-lapse.
The prime tower was required for the later successful multi-color workflow after an earlier freeze without it.

GENERIC / HS PLA CAT PRINT
Material profile: Generic HS PLA. Layer height: 0.18 mm.
Estimated print time: 1 hour 16 minutes. Supports were present in a related screenshot,
but the exact support settings were not recovered.

MULTICOLOR HS PLA ORANGE / BLACK JOB
Materials shown: Generic HS PLA and FlashForge HS PLA.
Total filament: 6.46 m / 19.26 g. Estimated print time: 1 hour 14 minutes.

UNRECORDED FIELDS
Temperatures, speeds, retraction, cooling, support values, purge volumes, and actual finished results
remain unrecorded unless shown above. Do not treat these job summaries as universal profiles.