CREATOR 5 PRO / FOUR-COLOR WORKFLOW
Record: DAT-0023 / Revision A
Status: Recovered workflow; not a complete material profile

RECOVERED SETUP
Printer: FlashForge Creator 5 Pro
Nozzle: 0.4 mm
Prime tower: Enabled
Slot 1: TPU 95A
Slots 2–4: PLA
Estimated print time: 12 minutes 44 seconds
Estimated material: 2.02 g
Visible send options: leveling, flow calibration, and time-lapse

OBSERVED RESULT
The printer previously froze during multi-color work when the prime tower was disabled.
Later prints worked with the prime tower enabled. Tower size and purge volumes remain dependent
on the model and materials.

RELATED RECOVERIES
Generic HS PLA cat print: 0.18 mm layer, about 1 hour 16 minutes, supports present but not fully recorded.
Orange/black multi-color print: 6.46 m / 19.26 g estimated, about 1 hour 14 minutes.